Table of Contents
Advertisement
Time-setting options
en
Checking time-setting options
If time-setting options have been set, the corresponding
symbols are lit up on the display. The symbol for which
the time is currently being displayed will be indicated.
To check the values for the different time-setting
options, touch the
button repeatedly until the
v
required symbol is indicated.
Setting the timer
The timer runs alongside other settings.You can set it at
any time, even if the appliance has been switched off. It
has its own audible signal so that you can tell whether it
is the timer duration or a cooking time that has elapsed.
The maximum time that can be set is 23 hours and 59
minutes. Up to 10 minutes, the timer duration can be
set in 30-second increments.Above 10 minutes, the
time increments become longer the higher the value.
The timer duration will start at a different default value,
depending on which button you touch first:
5 minutes if you touch the
you touch the
@
button.
Touch the
button until the timer symbol
v
1.
highlighted.
Use the
or
button to set the timer duration.
A
@
2.
After a few seconds, the timer duration will start to
count down.
If the set timer duration is the duration for which
Tip:
you wish to cook your food, use the cooking time. The
appliance will then switch off automatically when it has
finished cooking.
The timer duration has elapsed
An audible signal will sound. The timer duration will be
zero on the display.
Touch any button to switch off the timer.
Changing and cancelling
You can use the
or
A
@
duration at any time. After a few seconds, the change
will be applied.
To cancel, use the
button to reset the timer duration
A
all the way to zero. The timer is now switched off.
Checking time-setting options
If time-setting options have been set, the corresponding
symbols are lit up on the display. The symbol for which
the time is currently being displayed will be indicated.
To check the values for the different time-setting
options, touch the
button repeatedly until the
v
required symbol is indicated.
Setting the time
Once the appliance has been connected to the mains
or following a power failure, the clock will flash on the
display. Set the time.
The function selector must be set to the "Off" position.
22
button and 10 minutes if
A
V
button to change the timer
Use the
1.
The time will stop flashing.
Confirm by pressing the
2.
The appliance will apply the time you have set.
You can go to the basic settings to specify
Note:
whether or not the time should be shown on the display.
~ "Basic settings" on page 23
Changing the time
You can change the time again when you need to, e.g.
from summer to winter time.
To do this, when the appliance is switched off, touch the
button until the symbol for the time is underlined,
v
and use the
is
or
button to set the time.
A
@
button.
v
or
button to change the time.
A
@
Advertisement
Table of Contents
