InFocus IN124STx User Manual page 28

PIN Settings
PIN Protect: The PIN (personal identification number) feature allows you to
password protect your projector. Once you enable the PIN feature, you must
enter the PIN before you can project an image. Use the Up/Down/Left/Right
arrows buttons on the remote or keypad to set a 4-button press sequence. If
you enter an incorrect PIN 3 times in succession, the projector will automati-
cally shut down. If you lose or forget your custom PIN, contact InFocus Tech-
nical Support.
To enter the PIN at projector startup:
Power up the projector. The "Enter PIN" dialog box appears after the startup
screen. Enter the default PIN (Left/Right/Up/Down) or the new PIN if it has
been changed, using the arrow buttons on the remote or keypad. See the
description above for instructions.
To change the PIN:
Select "Change PIN..." in the Advanced Menu > Setup > PIN settings menu.
Enter the existing PIN. Enter the new PIN twice. Do not forget the new PIN.
Contact InFocus Support to recover a projector with a forgotten PIN.
Power
Power Saving Mode: When Power Saving Mode is On and the projector is in
standby (powered off but connected to AC power), Ethernet control, exter-
nal audio and the Monitor Out function will not work. This function is Off by
default.
AC Power On: When this feature is enabled, the projector automatically
turns on when power is connected. This allows control of ceiling mounted
projectors with a wall power switch.
Instant Power On: When this feature is enabled and it has been less than 1
minute since the projector was powered down, you can turn the projector
back on immediately. When this feature is disabled, you will need to wait for
the projector lamp to completely cool before restarting the projector.
Eco Blanking: When this feature is enabled and no video source is sensed,
70% of lamp power is saved and no image is shown. When the video source is
again applied, the image is shown immediately.
Source
Auto Source: When this feature is On, the projector automatically finds the
active source, checking the selected Power-up Source first. When this feature
is Off, the projector defaults to the source selected in Power-up Source. To
display another source, you must manually select one by pressing the Source
button on the remote or keypad and selecting one from the displayed Source
menu.
Power-up Source: determines which source the projector checks first for
active video during power-up.
Search Screen: allows you to display a blank screen (options include a blue,
black, white, or user-defined screen) instead of the default factory logo screen
at startup, and when no source is detected.
Timer
Auto Off Time: automatically turns the projector off after no signals are
detected for a preset number of minutes. If an active signal is received before
the projector powers down, the image will be displayed.
High Altitude Setting
High Altitude: We recommend you turn on the High Altitude Mode when
your environment is between 5000' (1500m) and 10,000' (3000m) above sea
level.
Network: allows you to configure the network settings for the Ethernet inter-
face.
Status/Service:
Source Info: a read-only display of current source settings.
Projector Info: a read-only display of current projector settings and lamp
hours.
27