Intex 126384GN Owner's Manual page 13

POOL ENCLOSURE SETUP
Once the pool has been filled with water, and it has been confirmed that it is completely level and that all
vertical legs are positioned in the middle of each patio block, proceed with the assembly of the pool
enclosure.
1. Top clamp installation
• Fasten a top clamp (13) to the T-joint of the pool frame from the underneath. Ensure the two bolts on
top clamp are facing upward. Repeat the procedure until all the top clamps are fastened to the T-joints
of the pool frame (see drawings 8.1 & 8.2).
2. Bottom cap and bottom rail installation
• Place a bottom cap (21) on the ground and align it with the leg cap. Ensure that the threaded side hole
in the bottom cap is facing outward. Place all bottom caps in position.
• Starting at any location, but always working in the same direction, connect a bottom rail (20) in between
two bottom caps (21). Ensure the pre-drilled holes on the bottom rail hook through the knobs on the
bottom cap. Repeat this procedure in a circular fashion until all the bottom rails and bottom caps have
been connected. Adjust the distance of the bottom cap to the leg cap by estimating that the support
post (14) will stand vertical after it is installed (see drawings 9.1 & 9.2).
3. Support post installation
• Remove the cardboard inserts from the both slides of each support post.
• Insert the support post (14) into the bottom cap (21). Lift up the support post slightly to let the slot on
the upper end of the support post hook onto the ridge at the top clamp. Push downward to ensure the
support post is connected firmly with the top clamp and inserted in the bottom cap (see drawings 10.1,
10.2 & 10.3).
• Repeat these procedures until all the support posts are joined to the top clamps and bottom caps
(see drawing 10.4).
SAVE THESE INSTRUCTIONS
8.1
9.1
10.1
(120IO) ENGLISH 7.5" X 10.3" PANTONE 295U 06/30/2020
English
8.2
9.2
10.2
Page 12
120A