Intex 126384GN Owner's Manual page 12

POOL SETUP (continued)
The last joint connection may be difficult to complete. You can
do it though, if you first simultaneously raisethe last joint and
beam about 2 inches (5 cm). Now, insert the beam into the joint
while lowering the pieces into position. The beam will easily
slide into the joint (see drawing 5.3). Ensure that the last joint
is fully connected before proceeding to connecting the legs.
3. Vertical legs assembly
• Attach the leg's end cap (3) to the bottom of each leg (2) first. With
the beams and T-joints assembly resting on the ground, slide one
vertical leg into the belt loop located in the middle of the pool liner
and insert th6e top of the leg into the bottom of the T-joint (1) (see
drawing 6.1). Continue the process with all the vertical legs.
• Lift the beams assembly and make sure all the legs are in a vertical
position (see drawing 6.2). Push all the T-joints downward to
ensure they are firmly connected to the legs.
• Pull gently, in an outward direction, the bottom of the leg making sure
the leg is vertical and perpendicular to the level ground.
4. Filling of the pool
• See Krystal Clear™ filter pump manual, install the strainer nuts, flat strainer rubber washers and threaded
strainer connectors on the liner pre-cut holes. Use strainer valve caps (16) and plug them into the
threaded strainer connectors from the inside of the pool so water will not run out while filling.
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check
to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting up
the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging and
a potential collapse of the pool. If the pool is not completely level, you must drain the pool, level
the area or move the pool to a different area that is level, and re-fill the pool, following the above
directions.
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool floor and pool
sides meet. Or, (from outside pool) reach under the side of the pool, grasp the pool floor and pull in
an outward direction. If the ground cloth is causing the wrinkles, have 2 people pull from opposite sides to
remove all wrinkles. Use the properly assembled pool ladder when entering or exiting the pool during this
process. Also make sure all the legs are vertical and perpendicular to the ground.
5. Fill the pool with water up to just below the sleeve line.
(see drawing 7).
SAVE THESE INSTRUCTIONS
(120IO) ENGLISH 7.5" X 10.3" PANTONE 295U 06/30/2020
English
1
1
2
3
2
3
WATER LEVEL
Page 11
120A
5.3
6.1
6.2
7