Table of Contents
Advertisement
Note:
In order to ensure the best detection and LoRaWAN
install LEO-S592-AQG0 as follows:
➢
There should not be any isolates or barriers in PIR and light detection range.
➢
Do not mount the device where the temperature is below/above operating range and
temperature varies greatly.
➢
Stay far away from any heat source or cold source like oven, refrigerator.
➢
Do not mount the device close to where airflow varies greatly like windows, vent, fan and air
conditioner.
➢
Do not mount the device upside down.
➢
Do not place the device right to the window or door. If you have to, you'd better pull the
curtain.
➢
It is recommended to install at least 1.5 m high from floor.
6. Device Payload
All data are based on following format(HEX), the Data field should follow little-endian:
Channel1
Type1
1 Byte
1 Byte
6.1 Basic Information
LEO-S592-AQG0 sensors report basic information of sensor whenever joining the network.
Channe
l
01(Protocol Version)
09 (Hardware Version)
ff
0a (Software Version)
0b (Power On)
0f (Device Type)
www.advantech.com
®
Data1
Channel2
N Bytes
1 Byte
Type
01=>V1
01 40 => V1.4
01 14 => V1.14
Device is on
00: Class A, 01: Class B, 02: Class C
communication effect, it is recommended to
Type2
Data2
Channel 3
1 Byte
M Bytes
1 Byte
Description
...
...
2 5
Advertisement
Table of Contents
