Desa CGDV32NR Owner's Operation And Installation Manual page 21

FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL - HRC100 AND
HRC200 SERIES
NOTICE: Use only alkaline batteries (not included).
Installing Remote Receiver
1. Open bottom louver and locate the switch bracket on the left.
2. Unscrew the switch bracket. Lean bracket forward so you are
able to access the back of the remote receiver.
3. Locate the battery clip mounted on the back of the receiver.
Slide a 9-volt alkaline battery (not included) through the clip
(see Figure 37).
4. Attach the terminal wires to the battery.
5. Connect wires from receiver to TH and TPTH to control valve
(see Figure 38).
6. Replace the switch bracket.
Receiver
9-Volt Alkaline
Battery
Battery Clip
Figure 37 - Attaching Alkaline Battery to Receiver
To Optional
Remote
Accessory
Figure 38 - Control Valve Terminals
116646-01B
Installing Optional Wireless Hand-Held Remote Control - HRC100 and HRC200 Series
Terminal Wires
www.desatech.com
FIREPLACE INSTALLATION
Removing/Replacing Glass Door
21
21