Table of Contents
Advertisement
Issue
Food remnants on dishware.
Detergent residue in the appliance Lid of the detergent dispenser is blocked by items of dishware and will not open.
Water spots on plastic parts.
Wipeable or water-soluble coatings
inside the appliance or on the
door.
There are stubborn white coatings
on the dishware, inside the
appliance or on the door.
Cause and troubleshooting
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 6
Tall narrow containers in corner areas are not rinsed out adequately.
Do not position tall narrow containers at too great an angle or in corner areas.
▶
Upper rack on right and left not set to same height.
Set the upper rack on the left and right to the same height.
▶
→ "Upper rack", Page 12
Arrange dishware in the upper rack so the tab collecting tray is not obstructed by
1.
dishware.
→ "Loading dishware", Page 19
Items of dishware are blocking the dispenser lid.
Do not place dishware or fragrance dispensers in the tab collecting tray.
2.
The lid of the detergent dispenser is blocked by the tab and will not open.
Position the tab in the detergent dispenser crosswise, not vertically.
▶
Tabs are used in the quick or short cycle. There is not enough time for the tab to
dissolve.
Select a more intensive Wash cycle or use Powder detergent.
▶
Detergent may lose its cleaning or dissolving ability after being stored a long time,
or the detergent is clumped together.
Change your Detergent.
▶
Droplet formation on plastic surfaces is unavoidable due to the laws of physics.
Water spots are visible after drying.
Select a more intensive program.
▶
Position dishware at an angle.
▶
→ "Loading dishware", Page 19
Use rinse aid.
▶
→ "Rinse aid", Page 17
Set the water softening system higher.
▶
→ "Setting the water softening system", Page 16
There is detergent residue. These coatings cannot generally be removed with
chemicals.
Change your Detergent.
▶
Scrub the appliance by hand.
▶
White coating is deposited inside the appliance.
Adjust the water softening system correctly.
1.
→ "Setting the water softening system", Page 16
In most cases you will need to increase the setting.
If necessary, change your detergent.
2.
Special salt dispenser is not screwed tight.
Screw the special salt dispenser tight.
▶
There is detergent residue. These coatings cannot generally be removed with
chemicals.
Change your Detergent.
▶
Scrub the appliance by hand.
▶
Hardness range is set incorrectly or the water hardness is too high.
Set the Water softening system to the water hardness or add special salt.
▶
3in1/organic/eco detergent is not effective enough.
Troubleshooting en-us
33
Advertisement
Table of Contents
