Table of Contents
Advertisement
►Self-cleaning recharger
Problem
The system outer foil
has not been
thoroughly washed.
The system outer foil
is not dry or is sticky.
ES-LS9A_AUS.indb
21
Action
If the shaver is not cleaned
for more than 2 weeks, first
clean with the cleaning
brush to remove beard
trimmings.
(See page 17.)
Do not add detergent and
water except when
replacing the cleaning liquid.
Doing so may deteriorate
the cleaning function.
(See page 18.)
After cleaning, oil‑like
droplets may remain on the
outside of the foil frame.
This is the lubricating
component of the cleaning
liquid and does not indicate
a problem. You may wipe it
off with a soft cloth.
The system outer foil may
not dry quickly due to
temperature conditions.
Run the "Dry/Charge" mode
again or wipe with a soft
cloth before shaving.
Problem
Do not insert any foreign
objects into the recharger.
Remove foreign objects in
The system outer foil
the cleaning tray. (See
cracks or deforms
page 18.)
during cleaning.
Replace the system outer
foil. (See page 17.)
If you mix soapy water or
hand soap with the
detergent or use another
detergent, the cleaning
liquid will foam. Use the
The cleaning liquid
self‑cleaning recharger after
has foamed.
thoroughly washing and
drying the shaver.
Replace the cleaning liquid.
(See page 18.)
Remove any waste, etc. that
has accumulated in the
drain at the bottom of the
cleaning tray.
(See page 18.)
Cleaning liquid has
accumulated in the
If you use the self‑cleaning
cleaning tray.
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may accumulate in the
cleaning tray.
Action
21
2022/08/31
11:19:05
Advertisement
Table of Contents
