Figure 18 Encrypt Connection Procedure - ZyXEL Communications PLA-4 Series User Manual

Chapter 4 The ENCRYPT Button

Figure 18 ENCRYPT Connection Procedure

5 Repeat step
must be done within 120 seconds of pressing the ENCRYPT button on the PLA-4xx.
6 Check the lights on the two powerline devices. The power (
lights should be blinking while the devices are connecting. Several times all lights blink
simultaneously and the HomePlug (
while your powerline devices connect.
If the power (
probably pressed the ENCRYPT button for too long. Try again, pressing the
ENCRYPT button for 1~ 2 seconds.
If the HomePlug (
powerline devices are not connected. Repeat steps 4 and 5 in this section. If
that doesn't work, see the Troubleshooting in Section 7.5 on page 71 for
suggestions.
7 To add more powerline devices to your network, press the ENCRYPT button on device
C (shown below) for more than 10 seconds until the power (
8 Then repeat steps
connected using ENCRYPT and the powerline device you want to connect (C). You
must use the ENCRYPT button on both devices.
38
press 2 seconds
4 in this section for the other powerline device you wish to connect. This
) light does not blink when you press ENCRYPT, you have
) lights on both powerline devices do not light up, the
4 and 5 in this section using any powerline device (A or B) you have
within 2
minutes
) and HomePlug (
) light also shows red. Wait for about one minute
PLA-4xx Series User's Guide
press 2 seconds
)
) light flashes.