steam ® Installation, Operation & Maintenance Instructions _____________________________________________________________________________________________ HOMEOWNER: INSTALLER: ___________________________________________________ ______________________________________________________ READ THIS ENTIRE INSTRUCTION MANUAL THOROUGHLY THANK YOU for selecting MrSteam Towel Warmer, the perfect BEFORE BEGINNING INSTALLATION. LEAVE THESE INSTRUC- addition to bathrooms, family spas, and exercise rooms within TIONS WITH HOMEOWNER.
steam ® Installation, Operation & Maintenance Instructions _____________________________________________________________________________________________ WALL PREPARATION CAUTION • DO NOT mount the Towel Warmer without providing structurally secure upper and lower headers as shown. • DO NOT mount the Towel Warmer directly to sheet rock or any other non-structural surface. Finished wall surface •...
steam ® Installation, Operation & Maintenance Instructions _____________________________________________________________________________________________ INSTALLATION: W328, W336 WARNING TO PREVENT SHOCK HAZARD, THE ELECTRICI- TY MUST BE TURNED OFF AT THE MAIN PANEL BEFORE ANY BOX CONTENTS: WIRING IS DONE. • Towel Warmer • (4) Mounting bolts •...
steam ® Installation, Operation & Maintenance Instructions _____________________________________________________________________________________________ ELECTRICAL CONNECTIONS 1. Assemble the BX cable BX Cable* connector to the wiring box (or greenfield) escutcheon as shown. WARNING TO PREVENT SHOCK HAZARD, Wiring Box Escutcheon THE ELECTRICITY MUST BE TURNED OFF AT NM (non-metallic) cable, NOTE: THE MAIN PANEL BEFORE ANY WIRING...
steam ® Installation, Operation & Maintenance Instructions _____________________________________________________________________________________________ GENERAL: The Towel Warmer requires 120 VAC, 50/60 Hz power. Specific amperage needed is listed in the Towel Warmer Specifications Chart on page 3 of this manual. A. Electrical connections should be made as prescribed by the National Electrical Code and local code.