D-Link DIR-615 User Manual page 66

DIR-615 Wireless N300 Router
Configuring via Web-based Interface
User Manual
Figure 56. The Connections Setup / WAN page. The advanced mode.
To create a new connection, click the ADD button in the Connections List section. Upon that the
connection creation page opens.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, on the Basic tab, mandatory settings of a WAN connection will be
displayed. To view all available settings of the WAN connection, go to the All Settings tab.
Change the needed parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the DELETE button. Also you can remove a connection on
the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, in the IGMP section, select the
choice of the radio button which corresponds to this connection (only for connections of the
Dynamic IPv4 or Static IPv4 type).
To forbid multicast traffic for all WAN connections, select the Disable choice of the radio button.
To use one of existing WAN connections as the default IPv4 or IPv6 connection, in the Default
gateway section, select the choice of the radio button which corresponds to this connection.
To return to the simplified mode, click the WANSIMPLEMODE button (the button is unavailable,
if several WAN connections are created).
Page 66 of 184