Toro XT Series Operator's Manual page 6

10. Lift the mower with the attachment lift lever or electric
lift and guide the fork to capture the hitch rod (Fig. 5).
11. Close the mid-mount hitch lock handle by rotating it
forward (Fig. 3).
5
4
Figure 5
1. Front mounting shaft
2. Fork
3. Spacer
Installing the Front Pulley Box
Install the front pulley box if it is not already installed.
1. Rotate the knobs to adjust the idler pulleys so there is a
1/4 inch (7 mm) clearance between the idler arms and
the mounting pins.
1
2 3
3 m–2825
4. Mid-mount hitch plate
5. Hitch rod
4
2
1
3
Figure 6
1. Mounting Pins
2. Idler arm
2. Make sure the front latches are open and then slide the
pulley box into the front hitch.
Note: Make sure the pulley box engages and closes the
latches.
3. Adjust both idler pulleys until they are totally to the
outside by turning the knobs.
4
1
Figure 7
1. Front hitch
2. Pulley box
6
4
1
3
2
m–6621
3. 1/4 inch (7 mm) clearance
4. Knob
3
m–6620
3. Knob
4. Idler pulley
2