Table of Contents
Advertisement
3.3 In s t a l la t io n E nv i r o nm e nt R e qui r e m e nt s
When selecting where to install, the following should be adhered to:
Install the equipment indoors and maintain air flow. Try to keep
1)
inlet/outlet free of dust;
The surface on which the equipment is installed should have sufficient strength to support
2)
the equipment and be as level as possible. T he equipment shall not shake once it is in
place;
The equipment adopts the incoming line and t h e outgoing line. I t is recommended to
3)
arrange lines and cables connected externally from the cable trenches to facilitate the
installation and maintenance;
Where the equipment is placed should provide sufficient space to allow the heat which is
4)
produced by the equipment to vent (see Fig. 3-2). Please do not cover the air inlet on the
front panel;
Do not use the equipment in an environment with dust, volatile or flammable gases, high
5)
saline matter or corrosive substances because these may affect the product life;
Do not place the equipment in an environment with high temperature or humidity. Keep
6)
away from water, heat sources and avoid direct sunlight;
Use correct power distribution to guarantee the safety of the equipment and the user's
7)
equipment.
Fig. 3-2 Schematic diagram of bottom of fixing device
5
the equipment air
Advertisement
Table of Contents
