Application Interface; General Mode - Saelig AFV Series Manual

5.4 A pp lic a t io n i n t er f ac e
In the application interface, users can conduct the operations of the general mode, Step
mode, Gradual mode and Measurement mode of the equipment.
Note: All the product information in the operation interface of the equipment should comply
with the model specifications of the actual equipment.

5.4.1 General Mode

【U Volt.】/【V Volt.】/【W Volt.】-- U-phase voltage/ V-phase voltage/ W-phase voltage:

The following three ways can be used for setting voltage at all phases:
Directly input the voltage value in
a)
and then input the voltage value;
In the box of
b)
Select
c)
【Freq】-- Frequency: Doing the setting is the same as that of voltage;

【LOW】: The equipment starts to output the low voltage when selected;

【HIGH】: The equipment starts to output the high voltage when selected;

【RUN】: The equipment starts the output according to the set value when selected;

【STOP】: The equipment stops the output when selected;

【RESET】: The equipment restores the initial state when selected;

】: AC indicator light displays the operational state of the AC output of the equipment:

【
Red represents that the mode of the equipment is in the stop state, while green
represents that the mode of the equipment is running.
Fig. 5-4 Setting interface of general mode
& to conduct the setting. The variation unit is 0.1.
. Click the box to pop up the keyboard,
, touch left and right for adjustment;
16