Andersen 400 Series Change Manual

Andersen 400 Series Change Manual

Lock mechanism
Hide thumbs Also See for 400 Series:

Advertisement

Lock Mechanism Handing Change Guide
for Andersen
A-Series Hinged Inswing & Outswing; 400 Series
®
Frenchwood
Hinged Inswing & Outswing Patio Doors and
®
400 Series Frenchwood
with Stormwatch
®
Read all instructions carefully before attempting this procedure. If you have any questions about your ability
to complete this procedure, call Andersen at 1-888-888-7020 for further direction. Andersen WindowCare
service center hours are Monday through Friday, 7 a.m. to 7 p.m. Central Time and Saturday, 8 a.m. to 4 p.m.
Central Time. Thank you for choosing Andersen
Every assembly and installation is different (windloads, structural support, etc.), and Andersen strongly
recommends consultation with an Andersen supplier or an experienced contractor, architect, or structural engineer
prior to the assembly and installation of any Andersen product. Andersen has no responsibility in regard to the
post-manufactured assembly and installation of Andersen products.
Use caution when working at elevated
heights and around unit openings. Follow
manufacturer's instructions for safe use of
ladder and/or scaffolding. Failure to do so
may result in injury or death.
Tools & Supplies
• Safety Glasses
• 1/8" or Smaller Flat Blade Screwdriver
Lock handing can be changed without removing
entire lock mechanism from panel.
"Andersen" and all other marks where denoted are trademarks of Andersen Corporation. ©1996-2009 Andersen Corporation. All rights reser ved.
Hinged Inswing & Outswing Patio Doors
®
Protection
products.
®
Follow manufacturer's
instructions for safe operation
of hand/power tools. Always
wear safety glasses. Failure to
do so may result in injury and/
or product damage.

Component Identification

1
Lock Mechanism Handing Change Guide
Windows and doors can be heavy.
Use safe lifting techniques and a
reasonable number of people with
enough strength to lift, carry and
install window and door products
to avoid injury and/or product
damage.
Lock Mechanism
Instruction Guide 0005204 BC
®
Revised 03/19/09

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 400 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Andersen 400 Series

  • Page 1 Lock Mechanism ▶ Lock handing can be changed without removing entire lock mechanism from panel. “Andersen” and all other marks where denoted are trademarks of Andersen Corporation. ©1996-2009 Andersen Corporation. All rights reser ved. Instruction Guide 0005204 BC Revised 03/19/09...
  • Page 2 Lock Mechanism Handing Change Guide 1. Pop Out Latch • Remove white packing clip covering latch. • Insert a 1/8" flat blade screwdriver into Latch Reversal Hole until it bottoms out. • Apply downward pressure on screwdriver handle while pulling Latch up and out, as shown. •...

Table of Contents