Table of Contents
Advertisement
6.5.4
Adjusting the saddle
6.5.4.1 Straightening the saddle
Position saddle in direction of travel. In doing
so, align the tip of the saddle with the top tube.
Figure 61: Positioning the saddle in direction of travel
Positioning the saddle with eightpins
suspension seat post
Only applies to pedelecs with this equipment
1 Position saddle in direction of travel. In doing
so, align the tip of the saddle with the top tube.
2 Use a torque wrench to tighten the seat post
axle with 8 Nm.
Figure 62: Tightening the seat post axle
MY22K0a - 52_1.0_30.11.2021
6.5.4.2 Adjusting the saddle height
To adjust the saddle height safely, either:
•
Push the pedelec near to a wall so that the rider
can lean on the wall to support themselves or
•
Ask another person to hold the pedelec.
1 Use the seat height formula to roughly set the
saddle height:
Seat height (SH) = inner leg length (I) × 0.9
2 Climb onto the bicycle.
3 Place your heel on the pedal and extend your
leg, so that the pedal is at the lowest crank
rotation point. Your knee should now be fully
extended.
Figure 63: Heel method
4 Take a test ride.
Riders should sit straight on the saddle at an
optimal saddle height.
•
If the pelvis moves to the left and right as you
pedal, the saddle is too high.
•
If your knees are painful after a few kilometres,
the saddle is too low.
Position the seat post according to needs if
necessary. Adjust the seat height with the
quick release.
Operation
75
Advertisement
Table of Contents
