General Safety Information - Breeze CPD 160 User Manual

We bring better air to life

1. GENERAL SAFETY INFORMATION

Ÿ Please read the user's manual carefully prior to installing and operating the unit.
Ÿ
This user's manual is the primary operating document intended for technical, maintenance and operations staff.
Ÿ
All user's manual requirements as well as the provisions of all the applicable local and national construction, electrical and
technical norms and standards must be observed when installing and operating the unit.
Ÿ The warnings contained in the user's manual must be considered most seriously since they contain vital personal safety
information.
Ÿ
Failure to follow the rules and safety precautions noted in this user's manual may result in an injury or unit damage.
After a careful reading of the manual, keep it for the entire service life of the unit.
Ÿ While transferring the unit control, the user's manual must be turned over to the receiving operator.
Disconnect the unit from power mains prior to any
installation operations.
The unit must be grounded!
Do not change the power cable length at your
own discretion. Do not bend the power cable.
Avoid damaging the power cable. Do not put any
foreign objects on the power cable.
Do not use damaged equipment or cables when
connecting the unit to power mains.
Do not touch the unit controls with wet hands. Do
not carry out the installation and maintenance
operations with wet hands.
Do not allow children to operate the unit.
Do not store any explosive or highly flammable
substances in close proximity to the unit.
Do not open the unit during operation.
Do not block the air duct when the unit is
switched on.
Ÿ
Before installing this product, ensure that the
voltage and frequency consistent with the
product nameplate.
Ÿ
When connected to power supply, all-pole
power switch with more than 3mm contact
separation is necessary to be installed on the
power supply circuit. Please do the connection
according to the local electrical equipment
technical regulations.
Ÿ Please set up vent and spot inspection.
Ÿ Installation height should be more than 2.3m.
Ÿ
Should be firmly installed. Gradient installation
forbidden.
The product must be disposed separately at the end of its service life. Do not dispose the unit
as unsorted municipal waste.
www.breeze.com.vn | breezefans@breeze.com.vn
UNIT INSTALLATION AND OPERATION SAFETY PRECAUTIONS
USER'S MANUAL
Unpack the unit with care.
While installing the unit, follow the safety
regulations specific to the use of electric tools.
Do not lay the power cable of the unit in close
proximity to heating equipment.
Do not operate the unit outside the temperature
range stated in the user's manual. Do not operate
the unit in aggressive or explosive environments.
Do not wash the unit with water. Protect the
electric parts of the unit against ingress of water.
Disconnect the unit from power mains prior to any
technical maintenance.
When the unit generates unusual sounds, odour
or emits smoke, disconnect it from power supply
and contact the Seller.
Do not direct the air flow produced by the unit
towards open flame or ignition sources.
In case of continuous operation of the unit,
periodically check the security of mounting.
Ÿ
Do not disassemble the junction box by
yourself, if the power cord is damaged, it
should repair by qualified serviceman
Ÿ Installation on window or outdoor is forbidden.
Ÿ
Places with overmuch lampblack or steam
forbidden.
Ÿ Below connection way of air duct is forbidden.
Pipe diameter shrinks
Multiple bend at connecting part
CPD SERIES
Duct
Adapter
< 0.8m
Outlet closed to crook
01