Table of Contents
Advertisement
Touch this button repeatedly to:
• Change the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option .
The water of the last rinse is not
drained out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum and the
final spin phase is not performed.
The display shows the indicator
The drum turns regularly to reduce
creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch Start / Pause button
appliance performs the spinning
phase and drains the water.
• Activate the Quiet option.
All spinning phases (intermediate spin
and final spin) are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch the Start / Pause button: the
appliance performs only the draining
phase.
• No Spin
.
Set this option to deactivate all spin
phases. The display shows the
indicator
. The appliance
performs the only draining phase of
the selected washing programme. Set
this option for very delicate fabrics.
The rinses phase uses more water for
some washing programmes
The appliance empties the
water out automatically after
approximately 18 hours.
7.10 Stains/Prewash
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Stains
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
.
compartment
will be added in the appropriate phase
of the washing programme.
This option is not
available with a
temperature lower than
: the
40 °C.
• Prewash
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
The options can increase the
programme duration.
.
These two options cannot be
set together.
7.11 WASH mode
When the appliance is switched on, the
led of this button lights on to indicate that
a washing cycle will be performed.
If you press this button when
drying or steam mode are
active, the cycle returns to
wash only mode. In this way
you can cancel drying and
steam mode during set up,
or the drying mode if you
pause the cycle before the
drying phase starts.
ENGLISH
19
. The stain remover
Advertisement
Table of Contents
