Performing A Local Hotsync ® Operation With The Cradle - Sony CLIE PEG-T415 Operating Instructions Manual

Performing a local HotSync
This section describes how to perform a HotSync
cradle (local HotSync), assuming that you have done all the necessary
preparations and installations for your CLIÉ handheld and your computer.
For the required preparations and software installation, and for information
on performing a HotSync for the first HotSync operation, see the Read This
First manual.
1
Place your CLIÉ handheld on the cradle.
2
Press the HotSync
The HotSync operation starts.
When the HotSync operation is complete, a message showing the
HotSync completion is displayed on your CLIÉ handheld.
Note
Do not remove your CLIÉ handheld from the cradle until the HotSync operation is
complete. Otherwise, the Palm Desktop for CLIÉ software may not quit normally.
If the HotSync operation does not start
Make sure that the HotSync
computer screen and Local Serial is not selected from the shortcut menu. If the HotSync
icon is not shown in the task tray, click Start, point to Programs (All Programs in
Windows® XP), Sony Handheld, and then click HotSync Manager. Press the HotSync
button on the cradle to start the HotSync operation.
Chapter3
Exchanging and updating data using a HotSync
®
operation with the cradle
button on the front panel of the cradle.
icon is displayed in the Windows task tray on your
®
operation
®
operation using the
102