Table of Contents
Advertisement
USING THE PROJECTOR
Control menu
Control device ID menu
ID definition can be set up by menu (range 0-99), and allow user control an individual projector by using RS232 command.
Note:
For a full list of RS232 commands, please refer to the RS232 user manual on our website.
Control remote settings menu
IR Function
Set the IR function setting.
‡
On: Choose "On", the projector can be operated by the remote control from the top and front IR
receivers.
‡
Off: Choose "Off", the projector can't be operated by the remote control. By selecting "Off", you will be
able to use the Keypad keys.
User 1 / User 2 / User 3
Assign a function to the User 1, User 2, and User 3 buttons on the remote control. It allows you to use the
function easily without going through the OSD menus. The available functions are HDMI 1, HDMI 2, Test Pattern,
Brightness, Contrast, Sleep Timer, Color Matching, Color Temp, Gamma, Projection, Light Source Settings, Zoom,
Freeze.
Note:
The User 1 / User 2 / User 3 function availablility depends on the remote control type.
The remote control layout may vary depending on the region.
Control keypad settings menu
Keypad Lock
When the keypad lock function is "On", the Keypad will be locked. However, the projector can be operated by the
remote control. By selecting "Off", you will be able to reuse the Keypad.
Control LAN menu
Configure the projector's network settings.
Network Status
Display the network connection status. (Read only)
MAC Address
Display the MAC address. (Read only)
DHCP
Turn on DHCP to automatically acquire IP address, subnet mask, gateway, and DNS.
IP Address
Assign the projector's IP address.
Subnet Mask
Assign the projector's subnet mask.
Gateway
Assign the projector's gateway.
DNS
Assign the projector's DNS.
40
English
Advertisement
Table of Contents
