An Event Created In The "Date Book" Application Cannot Be; I Cannot Transfer A Vcard Data Created With The "Address; Application On My Clié Handheld; I Cannot Beam Data - Sony CLIE PEG-NZ90 Frequently Asked Questions Manual

An event created in the "Date Book" application cannot
be listed in the week view
B In the Week view, you cannot select overlapping events that have the same
start time. If you have two or more events with the same start time, select
the Day view to view overlapping events.

I cannot transfer a vCard data created with the "Address"

application on my CLIÉ handheld
B The vCard data created with the "Address" application on your CLIÉ
handheld cannot be read by the Palm™ Desktop for CLIÉ software
because of its format "ver3.X." When you want to transfer Address data to
the Palm™ Desktop for CLIÉ software on your computer, perform a
®
HotSync operation (the vCard data created with the Palm™ Desktop for
CLIÉ software can be read by the "Address" application on your CLIÉ
handheld).
When you transfer vCard data to a device other than a CLIÉ handheld, the
data may not be displayed properly on the device if the data version is not
supported.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

I cannot beam data

Performing initial checks

B Tap General in the Preferences screen and check that Beam Receive
is set to ON.
B Make sure you point the IR port of your CLIÉ handheld directly at the IR
port of the target device.
B The distance between the devices is not proper.
Make sure the distance between your CLIÉ handheld and the target device
is 4 to 8 inches (approximately 10 to 20 centimeters). Best results of
beaming distance may vary depending on compatibility between devices.
30