Advertisement
Controls - PFH30R
The PFH30R is supplied with a wall mounted control unit. This
may be mounted on a wall in a convenient location away from
direct sunlight or draughty areas.
Using the mounting bracket as a guide, mark the hole positions
and drill and plug the wall to suit using the screws and wall
plugs provided.
The heat output is controlled by the thermostat, according to the
room temperature.
Turn the thermostat knob fully clockwise to maximum setting
initially. When the room is warm enough, reduce the setting slowly
until the heater just clicks off.
The heater will now cycle on and off to maintain your selected
room temperature. An audible click may be heard when the
thermostat operates - this is normal.
Note : If the heater does not come on when the thermostat is at
a low setting, this is normally because the room is warmer than
the thermostat setting and is not a fault.
* When the heat control is set to '
thermostat control to maximum.
Position '
' will turn the heater on and off to maintain a
temperature of approximately 5°C.
Thermal Safety Cut-outs
The power supply to the heater may also be interrupted if one or
a combination of the following abnormal events occurs:
1.
Air inlet or outlet grilles are obstructed.
2.
Internal ventilation is impaired due to build up of dust and
fluff.
3.
Blower unit stalls.
In the event that the above events occur the cut-out switches off
the heater automatically. To bring the heater back into operation,
remove the cause of the overheating, then turn off the electrical
supply to the heater for a few minutes. When the heater has
cooled sufficiently re-connect and switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
Glen Dimplex UK Limited
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire. SO30 2DF
[c] Glen Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.
' for cool blow, set the
UK customer help line (8.00AM – 6.00PM Mon-Fri; 8.30AM-1.00PM Sat)
Customer Services:
Republic of Ireland
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.
Cleaning
WARNING: DISCONNECT SUPPLY before carrying out
maintenance.
External appearance can be maintained by wiping occasionally
with a damp cloth. For stain removal, a weak soap solution can
be applied with a cloth and the surface wiped dry. Care must be
taken to avoid any moisture ingress into the product.
After Sales Service
Your product is guaranteed for
Within this period, we undertake to repair or exchange this product
free of charge (excluding element & subject to availability)
provided it has been installed and operated in accordance with
these instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales service you should contact our
customer services help desk on 0870 727 0101. It would assist
us if you can quote the model number, series, date of purchase,
and nature of the fault at the time of your call. The customer
services help desk will also be able to advise you should you
need to purchase any spares.
Please do not return a faulty product to us in the first instance as
this may result in loss or damage and delay in providing you with
a satisfactory service.
Please retain your receipt as proof of purchase.
Tel.
Fax.
e-mail
Tel.
one year
from the date of purchase.
0870 7270101
0870 7270102
customer.services@glendimplex.com
01 8424833
Advertisement
