After Operation; Shutting Off The Machine; Removing The Battery Pack From The Machine; Preventing Freeze-Up After Use - Toro 39924 Manual

After Operation

Shutting Off the Machine

1. Release the traction and auger/impeller levers.
2. Turn the key to the O
from the control panel
3. Remove the battery pack(s); refer to
the Battery Pack from the Machine (page
Note:
Whenever you are not using the machine,
remove the battery pack(s) and the key from
the machine.
Note:
If the machine is turned on and left idling
or operating without the auger engaged for an
extended period, the motor shutoff timeout will
engage, shutting off the machine. When the
machine shuts off this way it beeps to indicate
that the timeout was engaged.
To restart the machine refer to
Machine (page 17).
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery pack-latch to release the
battery pack and remove the battery pack
(Figure 26).
Figure 26
3. Close the battery-compartment lid.
position and remove it
FF
(Figure 12).
Removing
23).
Starting the
Preventing Freeze-up after
Use
•
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive
force when trying to operate frozen controls.
•
After using the machine, engage the auger to
clear any remaining snow from inside the housing.
Rotate the Quick Stick to prevent it from freezing.
Shut off the machine, wait for all moving parts to
stop, remove the key and the battery, and remove
all ice and snow from the machine.
•
Clean off any snow and ice from the base of the
chute.
•
Rotate the discharge chute to the left and right to
free it from any ice buildup.
g347853
23