Numeric Error Codes - Lenovo Thinkpad S2 2nd Gen Hardware Maintenance Manual

Numeric error codes

Table 2. Numeric error codes
Symptom or error
0177
Bad SVP data, stop POST task— Checksum of the
supervisor password in the EEPROM is not correct.
0183
Bad CRC of Security Settings in EFI Variable. Enter the
ThinkPad Setup program. – The checksum of the Security
settings in the EFI Variable is not correct.
0187
EAIA data access error
0188
Invalid RFID Serialization Information Area.
0189
Invalid RFID Configuration Information Area.
0190
Critical low-battery error
0191
System Security—Invalid Remote Change requested.
0199
System Security— Security password retry count
exceeded.
0271
Real-Time Clock Error. Check Date and Time settings.
1802
Unauthorized network card is plugged in—Power off and
remove the network card.
1820
More than one external fingerprint reader are attached.
Power off and remove all but the reader that you set up
within your main operating system.
2200
Machine Type and Serial Number are invalid.
2201
Machine UUID is invalid
36
13 2nd Gen and S2 2nd Gen Hardware Maintenance Manual
FRU or action, in sequence
Replace the system board.
1. Run the ThinkPad Setup program. The settings
will be corrected automatically. Then save the
current settings by pressing F10.
2. Replace the system board.
Replace the system board.
Replace the system board.
Replace the system board.
1. Charge the battery pack.
2. Replace the battery pack.
1. Run the ThinkPad Setup program, and then save
current setting by pressing F10.
2. Replace the system board.
1. Run the ThinkPad Setup program. The retry count
will be reset. Then save the current settings by
pressing F10.
2. Replace the system board.
1. Run ThinkPad Setup to reset the time and date
2. Replace the coin-cell battery and run ThinkPad Setup
to reset the time and date.
1. Remove network card.
2. Replace the system board.
Remove all but the reader that you set up for the
authentication.
Replace the system board.
Replace the system board.