Advertisement
Advertisement
Table of Contents
Related Manuals for MasterCraft MTHC-20JDLX
Summary of Contents for MasterCraft MTHC-20JDLX
-
Page 2: Grounding Methods
MPORTANT ARNING AFETY To reduce the risk of fire, electric shock or injury; NSTRUCTIONS Read all instructions before using this floor machine. 1) DO NOT leave the floor machine plugged because it has been dropped, damaged, left 14) DO NOT use around flammable or in when not in use. - Page 3 TTACHMENTS AUTION When installing or changing the accessories, turn OFF the sander NSTALLATION and disconnect the power cord from the electrical outlet. & C HANGING When installing or removing attachments, always wear protective gloves and start at the 12 o’clock position. 4) Push the attachments on by hand and if necessary, carefully tap it into place with a rubber mallet.
- Page 4 20” H & ANDLE SSEMBLY & RAWING ARTS ___________________________________ R R e e f f P P a a r r t t D D e e s s c c r r i i p p t t i i o o n n Q Q t t y y P P a a r r t t N N o o...
- Page 5 20” O UTER & RAWING ARTS _______________________________ R R e e f f P P a a r r t t D D e e s s c c r r i i p p t t i i o o n n Q Q t t y y P P a a r r t t N N o o...
- Page 6 20” I NNER & RAWING ARTS ___________________________________ ___________________________________ R R e e f f P P a a r r t t D D e e s s c c r r i i p p t t i i o o n n Q Q t t y y P P a a r r t t R R e e f f...
-
Page 7: Belt Changing
ACUUM ARNING PERATING IF THIS FLOOR MACHINE IS USED FOR SANDING, DO NOT LEAVE SAWDUST IN THE FILTER BAG WHEN THE NSTRUCTIONS MACHINE IS NOT IN USE. THIS IS A FIRE HAZARD. This machine can be used with a variety of Recommend separate dedicated power During operation, periodically check the vacuums to pickup wood and concrete dust. -
Page 8: Trouble Shootingg
ROUBLE HOOTING UIDE PROBLEM: Motor will not run. POSSIBLE CAUSE: POSSIBLE SOLUTION: 1) Defective switch. 1) Check switch, replace if defective. 2) Defective power cord or wiring. 2) Check and replace if defective. 3) Defective motor. 3) Have motor checked by an authorized service center. 4) Blown fuse or tripped circuit breaker at the wall panel.
Need help?
Do you have a question about the MTHC-20JDLX and is the answer not in the manual?
Questions and answers