Table of Contents
Advertisement
Quick Links
R
& F
EAD
W
ARNINGS
B
EFORE
This burnisher will afford you many years of
trouble free operating satisfaction if it is
given proper care. All parts have passed
rigid quality control standards before being
assembled to produce the finished product.
Prior to packaging, the units again inspect-
ed for assurance of flawless assembly.
Your burnisher was protectively packed to
prevent damage in shipment. We recom-
mend that upon delivery, remove the unit
from its carton and carefully inspect it for
any possible damage in transit.
S
AVE
1000 / 1500 / 2000 RPM
A
I
OLLOW
LL
& C
AUTIONS
U
T
SING
HIS
If damage is discovered, immediately notify
the transportation company that delivered
your burnisher. As a shipper, we are
unable to act upon any claim for concealed
damage. You must originate any claim
within 5 days of delivery.
These instructions are for your protection
and information. PLEASE READ CAREFUL-
LY! Failure to follow these precautions could
result in injury or discomfort.
T
I
HESE
NSTRUCTIONS
NSTRUCTIONS
B
URNISHER
P
1
AGE
Burnisher Manual - PN 344249 - Printed in USA 05/12/06
B
URNISHERS
S
AFETY
O
PERATION
M
AINTENANCE
M
ANUAL
,
R
I
NSTRUCTIONS
O
PERATING
,
&
A
EAD
LL
B
EFORE
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MasterCraft 1000
Summary of Contents for MasterCraft 1000
- Page 1 1000 / 1500 / 2000 RPM URNISHERS AFETY & PERATION AINTENANCE ANUAL & F OLLOW NSTRUCTIONS & C ARNINGS AUTIONS EFORE SING URNISHER This burnisher will afford you many years of If damage is discovered, immediately notify trouble free operating satisfaction if it is the transportation company that delivered given proper care.
- Page 2 MPORTANT AFETY ARNING To reduce the risk of fire, electric shock or injury: NSTRUCTIONS When using an electric burnisher, basic precautions should always be following, including the following: 1) DO NOT leave burnisher plugged in 8) DO NOT unplug by pulling on the cord. when not in use.
- Page 3 ROUNDING ETHODS This burnisher is for use on a nominal 120 The temporary adaptor should be used only NOTE: volt circuit, and has a grounding plug that until a properly grounded outlet (Fig A)can be In Canada, the use of a looks like the plug illustrated in (Fig A).
- Page 4 This burnisher requires limited maintenance 3) Unplug burnisher and check power cord ARE AND for proper operation and years of service. for and breaks in the wire. Breaks will most likely occur near the plug or switch. Any AINTENANCE 1) After each use, wipe off all of the polished breaks should be repaired or replaced and painted areas with a clean cloth.
- Page 5 2000 RPM The 2000 RPM burnisher should URNISHER only be used for high luster burnish- ing on floors that have a minimum of four (4) coats of floor finish. this will PERATING eliminate the possibility of damage to the floor due to the high speed of the burnisher.
- Page 6 ANDLE SSEMBLY NSTRUCTIONS This burnishers is shipped without the 1) Remove burnisher chassis and han- 3) Slide the handle assembly over han- handle attached to the chassis. Handle dle assembly for the carton. dle "T" on the chassis making sure the hardware kit (#372811) contains the line cord is towards back of burnisher necessary parts to attach the handle to...
Need help?
Do you have a question about the 1000 and is the answer not in the manual?
Questions and answers