Polaris RMK Shift Owner's Manual page 79

MAINTENANCE
Lubrication
Driveshaft Bearing
Fitting
Inject grease into the fitting on the speed-
ometer sensor housing until grease purges
from the seal on the inside of the tunnel.
This should take approximately two
pumps. Do not use more than four pumps.
Throttle Cable
Lubricate the throttle cable lightly
with grease or oil. With the
engine off, turn the handlebars to
the left and lubricate liberally as
shown.
Choke and Choke Cable
Lubricate the choke slide and
cables lightly with oil or grease.
Before turning the engine off,
operate the choke intermittently to
draw moisture out of the choke
plunger area and reduce the possi-
bility of the choke becoming fro-
zen.
76