Microsensor MTMK5883 Operation Manual page 9

If AL1H=AL1F, then this SP1 is closed.
Return difference = Abs (AL1H-AL1F).
SP2 settings are the same as SP1.
Tip: If you accidentally enter the factory menu, and some parameters are
changed, and the meter cannot work normally, please contact customer
service or dealers to guide you to restore to the factory settings!
8 Installation Guide
MTMK5883 can be directly installed on the pipeline through a threaded
interface. In critical applications (such as severe vibration or impact), the bellows
can be used for mechanical decoupling.
To prevent the influence of electromagnetic interference, the following
items should be paid attention to:
●The line connection should be as short as possible;
●Use shielded wire;
●Try to avoid direct access to the wiring of user devices, or electrical and
electronic devices that cause interference;
●Pre-system power supply, isolated power supply is recommended.
9 Responsibility
Under the condition that the user abides by the use and protection rules, the
instrument is guaranteed for one year from the date of shipment(except for
overload or human factors, etc.). Micro Sensor welcomes users to send inquires
at any time and make suggestions.
8