Distech Controls HS-RT Series Hardware Installation Manual

HS-RT Series
Room Humidity and Temperature Transmitters

Product Description

This document describes the hardware installation procedures for the HS-RT Humidity and Temperature Transmitters.
The HS-RT Series are room humidity and temperature sensors. They use a highly accurate and field-proven sensor, within a sleek,
elegant, and low profile enclosure, which is used to monitor, display, and communicate room relative humidity and temperature. Both
measurements signals are available on separate outputs as linear 4-20 mA, 0-5 or 0-10 Vdc signals. An LCD is included for
configuration and local indication of all parameters.
Several operating parameters can be programmed using a keypad for specific applications including four temperature ranges and C/F
display. For devices ordered with a concealed LCD, a solid plate cover is provided so the LCD is not viewable once the cover is
installed.

General Installation Requirements

For proper installation and subsequent operation of each device, pay special attention to the following recommendations:
-
Upon unpacking the product, inspect the contents of the carton for shipping damages. Do not install damaged device.
-
Avoid areas where corroding, deteriorating or explosive vapors, fumes or gases may be present.
-
Ensure that all equipment is installed according to local, regional, and national regulations.
Personal injury or loss of life may occur if you do not follow a procedure as specified.
Equipment damage or loss of data may occur if you do not follow a procedure as specified.
Take reasonable precautions to prevent electrostatic discharges to the controller when installing, servicing or operating
the controller. Discharge accumulated static electricity by touching one's hand to a well-grounded object before working
with the controller.
H a r d w a r e I n s t a l l a t i o n G u i d e
Figure 1: HS-RT Series Transmitters