Unpacking And Removing Shipping Material - LG WM4200HBA.ABLEEUS Owner's Manual

Dimensions and Clearances
Model WM4200H*A
D
E
F
G
Stacking or Pedestal Installation
The washer can be stacked under a dryer or on top
of a pedestal or pedestal washer.
A B C
Dimensions and Clearances
Model WM4200H*A
A 33 1/4" (84 cm)
B
C
D
E 77 1/2'' (196.8 cm)
F
NOTE
• Refer to the instructions packaged with the
optional pedestal kit before stacking appliance
on pedestal.
• Do not use a drain pan with a pedestal or
pedestal washer installation as it can block the
drawer. Using a drain pan may result in
increased vibration and noise during operation.
WM4000H*A
4'' (10 cm)
1'' (2.5 cm)
27'' (70 cm)
1/4'' (0.5 cm)
F
E
D C
WM4000H*A
30 1/4'' (77 cm)
4'' (10 cm)
1'' (0.5 cm)
27'' (70 cm)
1/4'' (0.5 cm)
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for
proper operation and inspect it for shipping
damage.
CAUTION
• Failure to remove shipping materials can cause
excessive noise and vibration.
Unpacking Shipping Material
*Some models do not ship with drum support.
Lift the washer off the foam base.
• After removing the carton and shipping
material, lift the washer off the foam base.
• Make sure the plastic drum support
off with the base and is not stuck to the bottom
of the washer.
• If you must lay the washer down to remove the
carton base , always protect the side of the
b
washer and lay it carefully on its side. Do not lay
the washer on its front or back.
Removing Shipping Material
1
Remove the bolt assemblies.
• Starting with the bottom two shipping bolts
, use the included wrench to fully loosen
c
all 4 shipping bolts by turning them
counterclockwise.
• Remove the bolt assemblies (bolts and
retainers) by wiggling them slightly while
pulling them out.
INSTALLATION
* comes
a
*
11