Advertisement
Available languages
Available languages
Pay attention to the following prior to start-up operation:
1.
Connect the heater only to power sockets that have been installed by a concessionary
electrician. For best possible protection of persons and facilities a safety protector switch (FI)
30 mA is mandatory.
2.
The heater may only be used in suitable containers (no plastic
containers and no containers that are not heat resistant).
3.
Do not touch liquids, when the heater is connected to the power
supply.
4.
Whilst heating up, the liquid may not drop below the upper edge of
the heater (see Fig.).
5.
Do not cover up unit during operation.
6.
The thermostat controls the temperature in the medium by automatically switching the current
on and off:
– button set to position „2" corresponds to a temperature of ca. +20° C.
– button set to position „7" corresponds to a temperature of ca. +40° C.
– button set to position „11" corresponds to a temperature of ca. +70° C.
– button set to position „max" corresponds to a temperature of ca. +100° C.
ATTENTION: When heating honey do not put over button position 4 (about 40 ° C)!
7.
During heating, the red indicator light flashes. Once the thermostat cuts off, the indicator light
stops flashing.
8.
When the desired temperature has been reached, disconnect the plug from the power socket
and leave the heater for about one more minute within the liquid.
9.
Unplug the heater before taking it off the liquid.
10. The heating element remains hot for a certain period in time even after disconnecting he plug
and should neither be touched nor put onto combustible surfaces.
11. The unit has to be cleaned after each and every use.
12. ATTENTION!!! Neither plastic lid nor plug may be immersed into liquid. Pay attention to "peak
level" position.
13. Do not leave the unit totally unobserved.
14. All repair work, e.g. the exchange of the connection lead may only be carried out through
Lister GmbH or an authorized specialist.
INSTRUCTIONS FOR USE
Advertisement
