Operating The Hood; Lamp Replacement - Beko HNS61210W User Manual

Using the appliance
3

3.3 Operating the Hood

• Hood is equipped with a motor having various
speed settings.
• For a better performance, we advise you to
use low speeds in normal conditions, and high
speeds when smell and vapors are intensified.
• You can start the hood by pressing the desired
speed level key.(c, d, e)
• You can illuminate the cooking area by pressing
the light key. (a)

3.4 Lamp replacement

• Before replacing the light bulbs,
disconnect the power supply of
the hood.
A
• Do not touch the light bulbs when
they are hot.
• Be careful not to touch the re-
placed light bulb directly with
hands.
C
You may procure lamps from
Authorised Service Agents.
MAX 3 W
• Candle type LED lamp is used in this product
• Max 3 W lamp must be used when the change
of lamp
Bulb
Bulb Power
10 / EN
3 W
Holder / Socket
Bulb Voltage
Size
ILCOS Code
Luminous flux
Correlated colour tem-
perature
This product contains a light source of energy ef-
ficiency class "E".
3.5 Operation with chimney
connection
• Vapour is extracted through the
flue duct, which is fastened to
the connection head on the
hood.
• The diameter of the flue duct must be the same
as the connection ring. In horizontal settings, the
pipe has to have a slight upward slope (around
10º) so that the air can exit the room easily.
3.6 Operation without chimney
connection
•
Air is filtered through the carbon
filter and recirculated in the
room. Carbon filter is used
when it is impossible to use a
flue in the house.
• In flueless use, remove the flaps inside the flue
adapter.
• Remove the aluminum grease filter. To install the
carbon filter, fit the filter to the tabs by centring
it on the plastic piece on both sides of the fan
body. tighten it by turning right or left.
• Replace aluminum grease filter.
Cooker Hood / User Manual
E 14
220 - 240 V
35 x 100 mm
D R B B / F - 3 - 2 2 0 -
240-E14-35/100
330 lm
2700 K