Honeywell HeatGenius HCE840 Series Manual page 4

6 HEAT SETTINGS THAT GIVE YOU CONTROL OF YOUR COMFORT
Once your heater is ON, use the control buttons on the front panel to select the desired heat setting for your
needs. Your heater will start on the Constant Hi Room heat setting each time you turn the heater on. Here is
a handy reference to help select the heat option that best suits your desired comfort level:
FLOOR AREA – (LOW HEAT)
This setting uses the lower level heating element only to provide a comfortable, gentle heat to warm up the
floor area in front of the heater.
PERSONAL – (MODERATE HEAT)
This setting uses a moderate heat level to warm you personally. The LO option (
using the upper level heating elements only, while the HI option (
you to adjust to your desired comfort level.
ROOM – (MODERATE-HIGH HEAT)
Best for whole room heating, use this setting to bring warmth to cooler, drafty rooms. The LO option
provides a moderate heat level, while the HI option uses maximum heat output to create a warmer
environment.
THERMOSTAT – (MODERATE-HIGH HEAT)
To set the Thermostat, press the Thermostat Control Buttons (
Temperature. The Desired Temperature will flash five times and then the Current Temperature in the room
will display as a steady number. The Thermostat can operate on either HI or LO heat levels to achieve
Desired Temperature by pressing the ( ) button under Room.
NOTE: If the Current Temperature is higher than your Desired Temperature, the heater will go into cool down
mode and then shut-off until the room temperature falls below this setting or until the Desired Temperature
is changed.
HEATPHASE™ TIMER
The new HeatPhase Timer is an auto-off feature that gradually transitions the room temperature from
TM
warmer to cooler. The timer starts at high heat and steps down 4 different heat levels until it shuts off - over
a 2 hour period. This feature is ideal for setting a comfortable, relaxing environment. (Fig. 2) The timer can
also be toggled to start at your desired level.
QUIET MODE
The new Quiet Mode features uses a low heat setting and fan speed to produce a gentle "white noise" and
soothing warmth. This setting uses an upper level heating element only. (Fig. 3)
Fig. 2
4
Fig. 3
2 Hour
Auto-off
Timer with
30 Minute
Phased
Intervals
) provides a soothing heat
) slightly increases heat output, allowing
) to choose your Desired
Gentle Heat
"White Noise"
Setting