Clean Air Filter; Replace Spark Plug; Replace Fuel Filter; Carburetor Adjustment - Craftsman 358.794941 Instruction Manual

CLEAN AIR FILTER
_" / Air Filter
_ Air Filter
Cover
Screws
A dirty air filter decreases engine per-
formance and increases fuel consump-
tion and harmful emissions. Always
clean after every 5 hours of operation.
Cleaning the air filter:
1. Clean the cover and the area
around it to keep debris from falling
into the carburetor chamber when
the cover is removed.
2. Remove parts as illustrated.
NOTE: Do not clean filter in gasoline
or other flammable solvent. Doing so
can create a fire hazard or produce
harmful evaporative emissions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Apply a few drops of oil to the filter;
squeeze filter to distribute oil.
6. Replace parts.
REPLACE SPARK PLUG
Replace spark plug each year to ensure
the engine starts easier and runs better.
Set spark plug gap at 0.025 inch. Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion CJ-6Y
spark plug and tighten securely
with a 3/4 inch socket wrench.
4. Reinstall the spark plug boot.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by run-
ning it dry of fuel, then remove fuel
cap/retainer assembly from tank. Pull
filter from tank and remove it from the
fuel line. Install new fuel filter on fuel
line; reinstall parts.
Fuel Filter
CHECK MUFFLER MOUNTING
SCREWS
Once each year, ensure muffler
mounting screws are secure and tight-
ened properly to prevent damage.
Mounting
1. Loosen and remove the 2 screws
from the muffler cover.
2. Remove the muffler cover.
3. Tighten the 2 muffler mounting
screws securely.
4. Reinstall muffler cover and 2
screws. Tighten securely.
CARBURETOR ADJUSTMENT
There is no screw for idle adjustment
on your blower. The throttle lever is
used to control engine speed. The
throttle lever can be placed in one of
four positions: STOP, IDLE or -Jl_,
FULLTHROTTLE or '1_, and one inter-
mittent position. If your engine will
not run properly or you require further
assistance, contact your Sears Service
Center or call our customer assistance
help line at 1-800-235-5878.
-10-