Advertisement
Operation (continued)
Approximate* Timer Dial Setting for Auto Drip
Grind
120V and 230V Models
100 & 190SS Series
Switch Up (0.75-15 sec)
Inside dial
Amount
Time
Desired
Setting
(oz.)
(seconds)
0.5
1
1
3
1.5
4
2
5
2.5
6
3
7
3.5
8
4
10
5
12
*You should check the weight of the coffee dispensed
to guarantee the time setting is delivering the amount
desired. Minor adjustments may be necessary. Different
roasts and blends of coffee may affect the time
required to obtain a desired throw weight.
Timer Adjustment
Range Switches [Equipped on timers 86456 (110V) &
86450 (230V)]
The timer dial can be set from 0.75 to 60 seconds by
using the range switch located to the left of the dial.
The range selection allows more precise time settings
from the dial for different throw weights.
Switch Up
Time: 0.75 to 15 seconds (refer to the inner ring of
numbers around dial)
Throw Weights: 1/2 oz. to 6 oz. of coffee
Switch Down
Time: 3 to 60 seconds (refer to the outer ring of
numbers around dial)
Throw Weights: 1.5 oz. to 27 oz. of coffee
4
Switch Down (3-60 sec)
Outside Dial
Amount
Time
Desired
Setting
(oz.)
(seconds)
6
15
8
20
10
25
12
29
14
34
16
39
18
43
20
48
25
60
Grindmaster
Setting the Timer:
Tools required:
Phillips screwdriver
WARNING
Unplug grinder to prevent electrical
shock.
1. Model 100: Remove lower cover plate (4
screws).
2. Model 190SS: First remove the (2) screws in
the timer cover behind the hopper. Now
remove the panel to access the timer.
3. Refer to the Approximate Timer Dial
Setting Chart to determine the proper
time setting for the amount of coffee you
wish to dispense.
4. Set the range switch to the proper position
as determined by the time required for your
desired portion.
5. Now set the timer dial. Be sure to use the
ring of numbers that correspond to the
range you have selected.
6. Check the weight of coffee dispensed to
guarantee the dial setting is delivering the
approximate
amount
adjustments may be required.
7. Once time is set, replace the cover plate or
access panel. Plug unit in.
Grinds
Before shipment, this grinder has been tested with
coffee and has been accurately adjusted to deliver
ground coffee to normal auto drip specifications.
The Grinding Burrs are made of an extremely hard and
wear resistant alloy. From time to time, grind
adjustments (see following instructions) may be
necessary as the burrs wear. If the grind runs coarser
than expected after normal adjustment and the grind
time has increased, the burrs may have excess wear and
should be replaced. New burrs should always be
installed as a pair, never one or the other, as they are
accurately ground and lapped in pairs. Old burrs
cannot be resharpened.
®
desired.
Minor
100 Series Coffee Grinders
Advertisement
