Table of Contents
Advertisement
Regular Maintenance
MAINTENANCE SCHEDULE
MAINTENANCE REQUIRED
Check auger gear case lubrication.**
Lubricate snowthrower.
Check tire pressure.
Change engine oil.*
Clean or replace spark plug.
Check drive linkage/belt tension.
Lubricate Axle Shafts.
Check / Lubricate Free-Hand Linkage.
Lubricate Auger Shaft.***
* Change original oil after two hours of operation.
** Check oil level each fall and spring.
✛ See your engine Owner's Manual.
***Lubricate each fall and spring.
CHECKING TIRE PRESSURE
The air pressure in each tire (Figure 8) should be equal
for both tires for best performance. Be sure to keep caps
on valves to prevent entry of debris into the valve stem
when tires are filled.
Size
PSI
15 x 5.0-6
20
4.80-8
20
16 x 6.5-8
14
AUGER GEAR CASE LUBRICATION
1. Place the snowthrower on a level surface.
2. Remove the pipe plug (A, Figure 9).
3. Check the lubricant level. It should be level with the
lower edge of the plug opening. If not, add The
Dealer Line Winter Weight Worm Gear Oil (available
from your dealer).
4. Re-install pipe plug, and tighten securely.
✛
✛
bar
1,38
1,38
,96
16
FREQUENCY
25 Hours
10 Hours
Monthly
50 Hours
✛
Yearly
4-6 Hours
Yearly
10 Hours
10 Hours
Figure 8. Checking Tire Pressure
Figure 9. Auger Lubrication
A. Pipe Plug
NOTES
Winter Weight
Worm Gear Oil
10W Oil and Grease
20 psi (1.37 bar)
See Engine Manual
See Engine Manual
N/A
Lithium Grease
10W Oil
Lithium Grease
Pipe Plug
Advertisement
Table of Contents
