Preparation; Remote Control - Philips BDS4231R/00 Manual

2486.1 gb
Care of the screen
Do not touch, push or rub or strike the screen with anything hard as this may scratch, mar or damage the
screen permanently. Do not rub with dust clothes with chemical treatment. Do not touch the surface with bare
hands or greasy cloth (some cosmetics are detrimental to the screen). Unplug before cleaning the screen. When
the surface becomes dusty, please wipe gently with absorbent cotton or other soft materials like chamois soaks.
Do not use acetone, toluene and alcohol because they cause chemical damage.
Do not use liquid cleaners or aerosol cleaners. Wipe off saliva or water drops as soon as possible. Their long
time contact with the screen causes deformations and colour fading.
Warning concerning stationary images on the screen
A characteristic of Plasma Display Panels is that displaying the same image for a long time can cause a
permanent after-image to remain on the screen. This is called phosphor burn in.
Normal use should involve the showing of pictures that contain constantly moving and changing images that fill
the screen.

Preparation

&
For ventilation, leave at least 5 cm free all
around the set.
To prevent any unsafe situations, no naked
flame sources, such as lighted candles, should
be placed in the vicinity. Avoid heat, direct
sunlight and exposure to rain or water.
The equipment shall not be exposed to
dripping or splashing.
é
Insert the aerial plug firmly into the aerial
socket x at the bottom.
For best picture quality use the suppressor-
aerial cable supplied.
" Insert the mains cord supplied into the mains
at the bottom and in the wall socket having a
mains voltage of 220-240V 50/60Hz.
To prevent damaging the power (AC) cord
which could cause a fire or electric shock, do
not place the set on the cord.
2
Great user manuals database on
11-10-2005 11:10 Pagina 2
UserManuals.info
'

Remote control:

Pull out the plastic insulation
sheet from the battery, this will activate the
remote control.
The battery supplied with
the appliance does not
contain mercury or nickel
CR 2025
cadmium so as to protect
the environment. Please
do not discard your used
batteries, but use the
recycling methods
available (consult your
distributor).
( To switch on the set, press the B key.
An indicator comes on and the screen lights
up.
If the set remains in standby mode (red
indicator), press the key on the remote
-P+
control.
The indicator will flash when you use the remote
control.