Samsung NX52T3510LV Manual page 13

• Connection Type 1
Proceed as follows:
• Screw the corrugated tube union (C) and the seal
(B) to the gas connection (A).
• Hold the corrugated tube union (C) in place with a
spanner and screw the connecting piece to a
flexible gas connecting hose (E).
•Tighten the clamp (D).
Only use approved sealing compound to seal the
thread.
• Connection Type 2 (Do not provided)
A
combination of connectors must be used to connect the range to the existing
gas supply line. Your connection may be different depending on the type of supply
line. size, and location.
1. Use the equipment specified in the figure below to connect the range:
supply tube built-In C.Oupllng and c.opper tube with
Yi"
to
the range Nipple
of
WNPT mnical washers that has the length
_ _ _ _ ___.. .......... [J) ............. :
~~~r !a':i:~th
Yi"
required
to
reach the gas supply
Gas
reguir
~ ~
Yi" Stopcock
t
~---u-1_
1
~
Coupling anct
NOTE: "Ille eQuipment shown for the installation is
not
provided with the range. Nipple of Y>"NPT
NOTE: Your range may
be
eQUipped from the
factory
with:
1.- Supply Tube or
2.- Gas
Shut"{)ff'Valve
2. Once connected to the gas lines, TURN ON the gas to the appliance and check
that there is no leakage by pouring foam on the connections and bends
in the tubes.
3. Check that the copper tube is not damaged or bent in such a way to block
the gas to the range.
EN-12