Advertisement
System Overview
Front View
259.6 (SP-6550)
224.4 (SP-6558)
Left Side View
Right Side View
SP-6558
SP-6550
SP-6558
5.5
5.5
Quick Setup
Installing Wall O-ring
Step 1. Place the Wall O-ring into the groove surrounding on the back
of the front bezel properly.
Installing Hooks For SP-6658
Step 1. Install SP-6658 system on the wall firmly.
Wall
Installing Hooks For SP-6650
Step 1. Install the mounting brackets into the mounting holes on
the four sides of SP-6550 using 9 x screws (M3x5mm).
The following messages are reminders for safety on how to protect your system from damages and to extend a long life of the system.
1. Check the Cable Voltage
•
The range of operating voltage should be between DC 9V and 36V. Otherwise, the system could be damaged.
2. Environmental Conditions
• Place your SP-6558 / SP-6550 on a sturdy, level surface. Be sure to allow enough space to have easy access around the system.
• Avoid extremely hot or cold place to install the system.
• Avoid exposure to sunlight for a long period of time or in an airtight space.
• Avoid the system from any heating device or using SP-6558 / SP-6550 when it's been left outdoors in a cold winter day.
• Bear in mind that the operating ambient temperature is from 0°C ~ 40°C for HDD & 0°C ~ 45°C for SSD.
• Avoid moving the system rapidly from a hot place to a cold place and vice versa because condensation may come from inside of the system.
• Placing SP-6558 / SP-6550 in strong vigrations may cause hard disk failure.
• Don't place the system close to any radio-active device in case of signal interference.
3. Handling
• Avoid putting heavy objects on top of the system.
Rear View (SP-6558)
C.L.100(VESA)
Rear I/O View
SP-6550
76
73.6
30.1
Top View
SP-6558
HDD Easy Maintenance
Step 1.
Pull out HDD tray.
Place the Wall
Step 2.
Release the two
O-ring into the
screws of HDD tray.
groove surrounding
the back of the
front bezel.
Heed the
be directed upwards when
you push back HDD tray.
Installing Memory Heatsink
Memory module
Wall O-ring
Step 2. Install 10 mounting hooks on the four sides of Panel PC and fasten the
mating screws to secure firmly.
Step 2. Mount SP-6550 Panel PC equipped with 9 brackets onto
the wall firmly.
Safety Precaution
Rear View (SP-6550)
C.L.100(VESA)
DC IN
LAN1
USB
Reset
9~36V DVI-D HDMI
LAN2
Connector
Button
Power
DC IN 9~36V
DVI-D
HDMI
LAN1
LAN2
Button
RESET
GND VCC
COM
COM2
COM1
I
C
Remote SW
2
PoE ON
Connector
1
2
I
C
COM
2
Connector
Remote
Switch
SP-6550
249.6
217.5
217.5
mark should
Step 3.
Release the four screws
of HDD tray.
Step 1. Attach the adhesive tapes on both sides of the
memory module.
Adhesive tape
click
Step 2. Put the click on to secure.
1. Install the hook.
2. Tighten the screw.
Wall
• Do not turn the system upside down. This may cuase the hard drive to mal-function.
• If water or other liquid spills into this product, unplug the power cord immediately.
4. Good Care
• When the outside of the case is stained, remove the stain with a neutral washing agent with a dry cloth.
• Never use strong agents such as benzene and thinner to clean the system.
• If heavy stains are present, moisten a cloth with diluted neutral washing agent or with alcohol and then wipe thoroughly with a dry cloth.
• If dust has been accumulated on the outside, remove it by using a special made vacuum cleaner for computers.
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
WARNING! Some internal parts of the system may have high electrical voltage. And therefore we strongly recommend that qualified engineers can open and disassemble the system. Please
handle LCD and Touchscreen with extra care as they are easily breakable.
Wall Mount Cut-out Dimensions
SP-6558
SP-6550
Mic In
Line Out
HDD & Memory & VESA Mount
Accessories
Memory Heatsink
HDD Tray
Screw
Memory Heatsink x 2
M3 x 5 mm Screw x 4
Installing VESA Mount
Hook Accessories (option)
M3x5mm screw
Mounting Brackets
x 9 for SP-6550
M4x35mm screw
Step 3. Install 9 hooks onto the mounting brackets on the four sides of
Panel PC and fasten the mating screws to secure firmly.
All Rights Reserved. Copyright 2017
(Unit: mm)
218.2
Wall
253
Wall
VESA Mount
VESA Mount Kit x 1
x 9 for SP-6550
x 10 for SP-6558
x 9 for SP-6550
Hook
x 10 for SP-6558
x 9 for SP-6550
1. Install the hook.
2. Tighten the screw.
Advertisement
