Table of Contents
Advertisement
Quick Links
Technical Manual
and
Replacement Parts List
Drop-in Freezers
MODELS: SKFDI18-ELUS1 115V
SKFDI18-ELEU2 230V
Marmon Foodservice Technologies
355 Kehoe Blvd., Carol Stream, IL 60188
Contact: (800) 328-3329
Silverking.com
FORM NO. 45322-SK REV E 09/2022
Specifications Subject to Change Without Notice.
1
Advertisement
Table of Contents
Related Manuals for Silver King SKFDI18-ELUS1 115V
Summary of Contents for Silver King SKFDI18-ELUS1 115V
- Page 1 Technical Manual Replacement Parts List Drop-in Freezers MODELS: SKFDI18-ELUS1 115V SKFDI18-ELEU2 230V Marmon Foodservice Technologies 355 Kehoe Blvd., Carol Stream, IL 60188 Contact: (800) 328-3329 Silverking.com FORM NO. 45322-SK REV E 09/2022 Specifications Subject to Change Without Notice.
-
Page 2: Technical Manual
INSPECT FOR DAMAGE AND UNCRATE Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following the instructions printed on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any evidence of mishandling. -
Page 3: Safety Precautions
Risk of fire or explosion. Flammable refrigerant used. Consult repair manual/owner’s guide before attempting to service this product. All safety precautions must be followed. Caution – Risk of fire or explosion. To be repaired only by trained service personnel. Use only Silver King approved replacement parts. Flammable refrigerant used. Caution –... - Page 4 SAFETY PRECAUTIONS (Continued): WARNING - Do not use electrical appliances inside the food/ice storage compartments unless they are of the type recommended by the manufacturer. WARNING - Appliances and their surroundings shall not attain excessive temperatures in normal use. WARNING - Do not use means to accelerate the defrosting process or to clean, other than those recommended by the manufacturer.
- Page 5 Your Silver King refrigerator is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty, terminate the manufacturers responsibility, and could result in serious injury.
- Page 7 R290 R PECIALIZED RECAUTIONS AND UIDELINES FOR ERVICING NITS SING EFRIGERANT: Qualification of Service Personnel/Workers: Required qualification of working personnel for maintenance, service and repair operations. Every working procedure that affects safety means shall only be carried out by competent persons. Examples for such working procedures are: ·...
- Page 8 Checks to the Refrigeration Equipment: Where electrical components are being changed, they shall be fit for the purpose and to the correct specification. At all times the manufacturer’s maintenance and service guidelines shall be followed. If in doubt, consult the manufacturer’s technical department for assistance.
- Page 9 Cabling: Check that cabling will not be subject to wear, corrosion, excessive pressure, vibration, sharp edges or any other adverse physical or environmental effects. The check shall also take into account the effects of aging or continual vibration from sources such as compressors or fans.
- Page 10 Charging Procedures: In addition to conventional charging procedures, the following requirements shall be followed. WARNING: Ensure that contamination of different refrigerants does not occur when using charging equipment. Hoses or lines shall be as short as possible to minimize the amount of refrigerant contained in them. WARNING: Cylinders shall be kept in an appropriate position according to the instructions.
-
Page 11: Operation
Defrost The Silver King freezer is a manual defrost unit. The unit should be defrosted whenever the walls accumulate a frost layer that is 1/4 inch thick. To defrost the unit, disconnect the Power Cord from the electrical receptacle and remove or open the Lid Assembly. After the frost has melted or come loose from the walls, wipe out the cabinet interior. - Page 13 REPLACEMENT PARTS LIST – SKFDI18-EL 115V/230V ITEM NO. PART DESCRIPTION PART NO. BREAKER STRIP (4 REQ'D) 42286-05 COMPRESSOR KIT 115V/60HZ (W/ ELECTRICALS) 11700-2 COMPRESSOR KIT 230V/50-60HZ (W/ ELECTRICALS) 11700-5 COMPRESSOR ELECTRICAL KIT (RELAY/OVERLOAD) 115V/60HZ 11701-2 COMPRESSOR ELECTRICAL KIT (RELAY/OVERLOAD) 230V 11701-5 GROMMET COMPRESSOR MOUNT 20481-SK...
- Page 16 90 DAY REPLACEMENT PARTS WARRANTY Silver King warrants to the original Equipment purchaser that a replacement OEM part thereof will be free of defects in material and workmanship, under normal use and service, for a period of 90 days from the date of original purchase of such replacement OEM part subject to all terms and conditions herein.
- Page 17 Silver King’s review to be inefficient or inoperative due to defects in material or factory workmanship.
-
Page 18: Product Ordering Information
An RMA (Returned Merchandise Authorization) form must be completed and then approved by Silver King. Please contact Silver King for details. Restocking fee will apply. All electrical equipment is single phase. Prices, designs, and specifications are subject to change without notice.