Bissell PROHEAT 2X LIFT-OFF 2072N User Manual page 9

PORTABLE SPOT CLEANING
MODE
C-6 Preparing the machine
1. Step on Portable Spot Cleaning Pedal to
release Portable Spot Cleaner.
2. Release Flex Hose by twisting Hose
Secure Latch clockwise. Unwrap Flex Hose
completely.
3. Attach desired cleaning tool to hose grip
until it snaps together. Make certain tool is
securely attached.
4. Twist Quick Release Cable Wrap
clockwise to unwrap Power Cable
completely and plug into grounded outlet.
Filling Formula & Water Tank
Follow instructions for filling tank in upright
cleaning mode in section C-1.
C-7 Cleaning with tools
Important! If using to clean upholstery,
check upholstery tags. Check
manufacturer's tag before cleaning. "W"
or "WS" on tag means you can use your
deep cleaner. If tag is coded with an "X" or
an "S" (with a diagonal stripe through it),
or says "Dry Clean Only," do not proceed
with any deep cleaning machine. Do not
use on velvet or silk. If manufacturer's tag
is missing or not coded, check with your
furniture dealer.
1. Attach cleaning tool of choice to end of
hose.
2. Hold tool approximately 2.5 cm above
soiled surface. Press Spray Trigger to apply
cleaning solution to soiled area.
Caution: Do not overwet.
NOTE: Hold end of hose below tank
water level to help prime the portable
spot cleaner.
3. Using brush on tool, gently scrub the
area to be cleaned.
4. Apply downward pressure on tool and
pull it toward you. The suction will remove
dirt and cleaning solution. Continue until no
more dirt can be removed.
IMPORTANT
Check for colourfastness in an inconspicuous place. If possible,
check upholstery stuffing. Coloured stuffing may bleed through
fabric when it becomes wet.
Empty Dirty Water Tank
Follow instructions under Empty Dirty Water
Tank in section C-4.
C-8 Cleaning Portable Machine
1. Before turning off machine, suction up
clean water from a bowl or from tap to
rinse out interior of the hose. Then, lift the
Cleaning Tool and point it upwards to drain
any remaining water into tank.
2. Remove and rinse tools in clean, running
water. Dry and replace in tool storage
provided.
3. Coil Flex Hose around Hose Wrap and
secure with latch.
4. Check suction gate and if it appears dirty,
follow steps 1-4 under Cleaning Suction Gate
in section D-1.
C-9 Replacing Portable Machine
on base
1. Align machine as graphic shows, with
cable side on left and hose side on right.
2. Push down Portable Spot Cleaner until
it can be heard clicking securely into place.
Test fit by pulling up on Carry Handle to
make sure it is secure.
www.BISSELL.eu
9