Toyotomi zibro LC-300 Operating Manual page 11

Without the 'SAVE' setting your heater will maintain the set temperature by
!
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
K
tHe 'fuel' inDicatOR
When the FUEL indicator appears, it means that there is only fuel left for 10
more minutes. The count-down of the remaining heating time can be seen in the
information display K (Fig. K).
You remove the fuel tank and refill it outside the living room (Section B).
In the display the number 10 will appear, you will hear an alarm signal every
two minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
when it switches off. The fuel indicator will blink, while four lines (--:--) are
blinking in the information display. You can stop this by pressing the
L once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
l
tHe 'vent' inDicatOR
When there is insufficient ventilation in the room, the heater shuts off
automatically. When this occurs, e -1 1 is displayed and the VENT indicator
blinking (fig. L). After improving the ventilation of the room (e.g. by opening a
door or window a little more), the heater can be ignited by pushing the
L again.
M
Maintenance
Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains. Your heater needs hardly any
maintenance. It is, however, important that you clean the vent filter 8 with a
vacuum cleaner and the grid 2 with a damp cloth, both on a weekly basis.
Regularly inspect the fuel filter as well:
1 Remove the removable tank 6 from the heater and remove the fuel filter
(Fig. M). Some drops may leak from the filter; keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-down against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp
cloth, because otherwise these may cause stains that are hard to remove.
!
Do not remove any heater components yourself. Always contact your dealer
for repairs. When the power cord is damaged, it may only be replaced by an
authorised fitter. Use a new cord of the type H05 VV-F.
4
10
K: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
button
is
L: A blinking VENT
button
indicator is a sign
that you need extra
ventilation.
Fuel filter
M