Page 1
R200 Monitor Installation and Setup Guide English Page Nederlands Pagina 10 Deutsch Seite Français Page Español Página 31 Italiano Pagina 38 R200C2-A Manual R200C2-A version: 7...
1. Introduction Thank you for the purchase of this carbon dioxide monitor. Carbon dioxide is also known as CO . This product is designed for measuring CO concentrations as well as air temperature and humidity. To be used at home, office, school, canteen, etc. The CO monitor adapts itself to its environment (auto calibration).
Page 4
4. Where not to install the device In an enclosed space (for example in a cupboard or behind a curtain). Where it can be obstructed (for example by furniture). Directly above a sink. Next to a door or window. Next to an extractor fan. Next to an air vent or other similar ventilation openings.
Page 5
When CO concentration is 1500 PPM, the status indicator turns red and a 75db@1m alarm is emitted. Take actions recommended in Section 8 to prevent risks to your health and safety. 7. Explanation operation buttons Short press to switch between temperature, humidity and CO display.
Page 6
9. Carbon dioxide levels and guidelines 400 PPM Normal outdoor air level 400 ~ 1000 PPM Typical level indoors with good ventilation. NOTE: If CO levels are low when building is sealed and occupied, check for overventilation (too much fresh air = energy wasted). >1000 PPM ASHRAE and OSHA recommended maximum level in a closed room.
: Net weight 291gr 13. Service and Contact For questions about the installation, use or operation of this product please visit www.resideo.com and use the search engine to find more information. Please Note: While every effort has been made to ensure accuracy in this publication, no responsibility can be accepted for errors or omissions.
Page 8
Product. If any Product becomes defective during the applicable warranty period for a reason that is not excluded below, Resideo will, at its sole option, either repair or replace free of charge with a new or re-furbished product, or credit to Buyer's account the price paid for the Product.
Page 9
Resideo will destroy any Product that it determines to be defective. If Resideo does not find the Product defective, Resideo reserves the right to charge the Buyer for the reasonable costs of its investigation of the alleged defect. If Buyer pays Resideo in advance for the costs of returning the Product, Resideo will send the non-defective Product back to Buyer but otherwise Resideo will destroy the Product.
Need help?
Do you have a question about the R200 and is the answer not in the manual?
Questions and answers