Black Box CCTVTEST Manual page 19

SELECT UTP CABLE TEST MODE: Press the "3" key to enter the UTP test mode.
START TEST: Press "SET." The CAT5/6 UTP cable wire map will be displayed on the
LCD screen.
RETURN TO MAIN MENU: Hold the MENU key to return to the Main Menu.
TESTER SIDE
PIN NUMBERS
Typical CAT5/6
Cable (UTP)
Wiremap
3.4.4 Selection 4: Video Generator: Testing a monitor using the VIDEO OUT port.
Connection. Connect the monitor to the tester using the VIDEO OUT jack:
Without camera
Drive the monitor with the tester's video generator. Or drive the monitor
with a camera "looped" through the tester.
SELECT VIDEO GENERATOR MODE: Press the "4" key to turn ON the video
generator.
724-746-5500 | blackbox.com
Get other manuals https://www.bkmanuals.com
UTP CABLE TEST
1 ----------------------
2 ----------------------
3 ----------------------
4 ----------------------
5 ----------------------
6 ----------------------
7 ----------------------
8 ----------------------
Figure 3-5. UTP cable test wiremap.
Figure 3-6. Video generator test setup.
Chapter 3: Operation
1 REMOTE
2 PIN NUMBERS
3
0 "0" means open
0 Two "0"s is a
6 short circuit
7
8
With camera
Page 19