Using The Brush; Step One: Clear Work Area; Step Two: Using The Brush - North Star 1572215 Owner's Manual

Soft wash brush
Table of Contents

Advertisement

Step 1: Clear work area.
1. Clear work area
2. Prep work area
Step 2: Using the brush.
• ALWAYS wear personal protective equipment as directed on the chemical
label.
• Long pants and sleeves, chemical-resistant gloves, and eye protection are
strongly recommended. Additional protective gear may be required depending
on the particular chemical.
1. Review safety
information
2. Wear personal
protective
equipment
3. Attach to spray
gun or soft wash
telescoping wand
4. Operating the
brush
Operation – Using the Brush
Clear the work area of all bystanders and pets.
Restrict access by the public for the period recommended on chemical labels.
Complete the following before use:
a)
Cover all electrical outlets and light fixtures on surfaces near the work
area.
b)
Remove any decorations in proximity to work area.
c) Using fresh water from a garden hose, soak any vegetation that may come
into contact with soft wash mix. If cleaning roof with gutters, soak area
around downspouts with fresh water.
WARNING
Review the Summary of Important Safety Information section provided in this manual.
Wear personal protective equipment as directed on the chemical label. Goggles, gloves,
long sleeves, and pants are recommended while mixing chemical.
NOTE: Clothes may be damaged by bleach.
To attach brush to spray gun:
1. Make sure the system is off and depressurized.
2. To install the brush, pull the collar back on the spray gun to be used and twist the brush
firmly into the coupler on the end of the spray gun lance.
3. Release the collar, making sure it springs back and re-seats to its original (non-retracted)
position. Check the connection by pulling on the brush to ensure a tight connection. If
correctly inserted, the brush will rotate but not pull out.
Collar
Spray gun lance
To operate the brush:
Pull the trigger of the spray gun or telescoping wand it is attached to. The soft wash mix will
begin to flow to the bristles. Once there is flow from the bristles the surface can be agitated
with the bristles.
11

Advertisement

Table of Contents
loading

Table of Contents