Braun Silk epil 3 5320 Instruction Manual page 9

provided with the massaging rollers
attachment.
To turn on the appliance, slide up the
on/off switch (4):
Setting I: extra gentle
Setting II: extra efficient
When switched on, the switch light
illuminates the area to be epilated.
Rub your skin to lift short hairs. For
optimal performance, hold the appliance
at a right angle (90°) against your skin
and guide it without pressure against the
hair growth, in the direction of the switch.
The massaging rollers (1) stimulate the
skin before and after the hair is pulled out
for an extra gentle epilation experience.
Leg epilation
Epilate your legs from the lower leg in an
upward direction. When epilating behind
the knee, keep the leg stretched out
straight.
Underarm and bikini line epilation
Please be aware that especially at the
beginning these areas are particularly
sensitive to pain. Therefore, we
recommend that you start with switch
setting I. With repeated usage the pain
sensation will diminish.
Before epilating, thoroughly clean the
area to remove residue (like deodorant).
Carefully dab the area dry with a towel.
When epilating the underarm, keep your
arm raised up and guide the appliance in
different directions.
Cleaning
After epilating, unplug the appliance,
remove the massaging rollers and clean
the epilation head (2). Thoroughly clean
the tweezer element with the cleaning
brush dipped into alcohol. While
cleaning, you can turn the tweezer
element manually.
To remove the epilation head, press the
release buttons (3) on the left and right
and pull it off. After cleaning, place the
epilation head and the massaging rollers
back on the housing.
Shaving
(see picture section B)
The shaver head (7) is designed for a fast
and close shave of legs, underarms and
bikini line, contour trimming and cutting
hair to 5 mm length. Use the shaver head
with speed II.
For cutting hair to 5 mm length, put on
the trimmer cap (a).
Cleaning
Tap the shaver foil frame (b) on a flat
surface. Do not clean it with the brush as
this may damage the foil.
The shaving parts need to be lubricated
regularly every 3 months.
Replace the foil frame (b) and cutter
block (c) when you notice a reduced
shaving performance. Replacements
parts can be obtained from your retailer
or Braun Customer Service Centers or via
www.service.braun.com. Do not shave
with a damaged foil.
Subject to change without notice.
9