Advanced Menu - Philips C Line 75BDL6051C User Manual

75BDL6051C 86BDL6051C
Configuration reset
Reset all settings in Configuration menu to the factory preset
values.
Factory reset
Reset all settings in {Picture}, {Screen}, {Audio},
{Configuration1}, {Configuration2}, and {Advanced option}
to the factory preset values.
Press [ ] or [ ] button to select [Reset], and then press
[RESET] button to do the reset.
System will be in media player mode after factory reset.
Factory reset
CANCEL

6.2.5. Advanced menu

IR control
Select the operation mode of the remote control when
multiple displays are connected via RS232C connection.
• {Unlock} - All displays can be operated normally by the
remote control unit.
• {Primary} - Designate this display as the primary display
for remote control operation. Only this display can be
operated by the remote control. (In primary mode, IR key
will always be processed regardless of the monitor ID/
group settings.)
• {Secondary} - Designate this display as the secondary
display. This display can not be operated by the remote
control, and will only receive the control signal from the
primary display via RS232C connection.
• {Lock All} / {Lock all but Volume} / {Lock all but Power}/
{Lock all except PWR & VOL} - Lock the remote control
function of this display. To unlock, press and hold the
[Info] button on the remote control for more than 6
seconds. It will exit from OSD menu automatically after
locking IR.
No warning message will be shown when IR control is
locked.
Keyboard control
Choose to enable or disable the display keyboard (control
buttons) function.
• {Unlock} - Enable the keyboard function.
RESET
36
• {Lock All} / {Lock all but Volume} / {Lock all but Power}/
{Lock all except PWR & VOL} - Disable the keyboard
function depending on the option you selected.
NOTE: "Keyboard Control Lock Mode" This function
completely disables the access to all Keyboard
Control functions. To enable or disable the
keyboard control lock, press both [VOL+] and [UP]
buttons and hold down continuously for more than
3 (three) seconds.
Off Timer
Set automatic power off time (in hours).
Schedule
1. Default start time and end time are 00:00.
2. Start time and End time must be from the same date of
the schedule.
■ Set lifecycle.
- Back:
■ Exit without saving changes.
- Save:
■ Save schedule data.
HDMI with One Wire
CEC control.
• {Off} - Disable CEC.(Default)
• {On} - Enable CEC.
The following features are supported:
• One Touch Play allows devices to switch the display to
use it as the active source when playback starts.
• System Standby enables users to switch multiple devices
to standby mode with the press of one button (HDMI
with One Wire Power off is On).
Auto signal detection
This function allows the system to detect and display the
available signal sources automatically.
Conditions for Auto Signal Detection:
1. Sub mode is "Off"