Table of Contents
Advertisement
3. Remove any residue and clean filters
under running water.
4. Re-install filter system in reverse
sequence and ensure that the arrow
marks are opposite each other after
closing the filter system.
Spray arm
Limescale and dirt from the rinsing
water may block nozzles and the
bearing assemblies of the spray
arm 1".
1. Check outlet nozzles on the spray
arm for blockages.
2. Remove the spray arm upwards.
3. Clean the spray arm under running
water.
4. Lock the spray arm into position.
Fault, what to do?
Fault, what to do?
F a u l t ,
w h a t
Experience has shown that you can
rectify most faults which occur in daily
operation yourself. This ensures that
the machine is quickly available to you
again. In the following overview you can
find possible causes of malfunctions
and helpful information for rectifying
them.
Note
If the appliance stops during
dishwashing or does not start for no
obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled "Operating
the appliance")
m
Warning – Don't forget: Repairs may
be carried out by technicians only. If a
component has to be replaced, ensure
that only original spare parts are used.
Improper repairs or use of non-original
spare parts may cause considerable
damage and put the user at
considerable risk.
en
t o
d o ?
21
Advertisement
Table of Contents
