STEP 5:
(SEE FIGURE 6)
•
Spread ends of bumper enough to fit slots onto bolts
in rear mounting holes in tractor frame.
•
The bumper has three mounting holes. The rear
hole provides the most clearance while the forward
holes provide a neater appearance. Use a hole
that provides enough clearance for hood to stay in
raised position when opened. Insert a carriage bolt
and washer through tractor frame and into desired
mounting hole on each side of bumper and secure
with a whizlock nut.
IMPORTANT: Before fully tightening nuts, be sure
tractor hood will stay in raised position when opened.
STEP 6:
(SEE FIGURE 7)
•
Replace the browning shield using the front screws
you removed in Step 2.
4
HEX BOLT
AND WASHER
REPLACE
FRONT SCREWS
REPLACE
BROWNING SHIELD
Call 1-866-576-8388 for missing parts or assembly help
WHIZLOCK NUT
FIGURE 6
FIGURE 7
DO NOT RETURN TO STORE