Changing The Programme Default Settings; Selecting Additional Programme; Settings; Placing Laundry Into The Drum - Bosch WAN Series Instruction Manual And Installation Instructions

Operating the appliance
en
Spin speed,
■
The maximum load and the duration
■
of the programme (alternately)
Changing the programme
default settings
You can use the default settings or
change them.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The settings are activated without
needing to be confirmed.
They are not saved when the appliance
is switched off.
~ "Programme default settings"
on page 25
Overview of programmes ~
Supplementary sheet for the operating
and installation instructions.
Selecting additional
programme settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The indicator lamp for the button lights
up if a setting is active.
The settings are not saved when the
appliance is switched off.
~ "Additional programme settings"
on page 26
Overview of programmes ~
Supplementary sheet for the operating
and installation instructions.
28

Placing laundry into the drum

:
Warning
Risk of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
Notes
Mix items of laundry of varying sizes.
■
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual items of
laundry may lead to imbalances.
Observe the specified maximum
■
load. Overfilling has a negative
impact on the washing result and
promotes creasing.
Place presorted items of laundry
1.
unfolded in the washing drum.
Make sure that no items of laundry
2.
are trapped between the washing
machine door and the rubber seal,
and close the door.
The Inicio/Pausa A (Start/Reload)
button indicator lamp flashes to indicate
that the washing programme can be
started. It is possible to change the

settings.

~ "Programme default settings"
on page 25
~ "Additional programme settings"
on page 26